Special Gas Requirements (Gas Models Sold In Massachusetts); Electrical Requirements - Samsung NX58 565 Serie Manuel D'installation

Cuisinière à gaz non encastrable
Masquer les pouces Voir aussi pour NX58 565 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation requirements

Special gas requirements (Gas models sold in Massachusetts)

Commonwealth of Massachusetts requirements:
WARNING
Gas leaks may occur in your system, creating a dangerous situation.
Gas leaks may not be detected by smell alone.
Gas suppliers recommend you purchase and install a UL-approved
gas detector. Gas detector should be installed in accordance with the
manufacturers instructions.
Range must be installed by a qualified plumber or gas fitter by the State of
Massachusetts.
A T-handle manual gas valve MUST be installed in the gas supply line to
your range.
If a flexible gas connector is used to install your range, multiple flexible gas
lines must not be connected in series.

Electrical requirements

WARNING
To reduce the risk of fire, electric shock, or personal injury:
All ranges
Do not use an extension cord or adapter plug with this range.
This range must be properly grounded.
Check with a qualified electrician if you are in doubt as to whether your range
is properly grounded.
Do not modify the plug provided with your range—if it doesn¡¯t fit the outlet,
have a proper outlet installed by a qualified electrician.
All wiring and grounding must be done in accordance with local codes or, in
the absence of local codes, with the National Electrical Code, ANSI/NFPA No.
70 – Latest Revision (for the U.S.) or the Canadian Electrical Code CSA C22.1 –
Latest Revisions and local codes and ordinances.
Wiring diagram is located on the back of the range. (Inside of the cover back
wire)
This range is equipped with an electronic ignition system that will not operate
if plugged into an outlet that is not properly polarized.
Gas models
All gas models are equipped with a power cord with an equipment-grounding
conductor and a grounding plug.
A 120-Volt, 60-Hz, AC, approved electrical service with or 20-amp circuit
breaker or time-delay fuse is required for all U.S. and Canadian models.
Check for ¾" (1.9 cm) UL-listed strain relief where the power cord comes out
of the range cabinet.
Do not reuse a power supply cord from an old range or other appliance.
The power cord electric supply wiring must be retained at the range cabinet
with a suitable UL-listed strain relief.
A time-delay fuse or circuit breaker is also recommended.
English 19

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Nx58 560 serie

Table des Matières