AEG MPS 4920 Mode D'emploi page 44

Set manucure - pédicure
Masquer les pouces Voir aussi pour MPS 4920:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
English
44
• Hard skin can be removed easily when dry. Do not remove the complete callus in order
to maintain the natural protection of the skin.
Water or skin lotions impair the progress of treatment. If necessary, briefly wash your
feet and then dry thoroughly.
NOTE:
To prevent the skin on your hand from cracking, apply a moisturizing lotion after treat-
ment.
Startup operation
1. Charge the rechargeable battery of the motor unit (see chapter "Charging the bat-
tery").
2. Attach the required attachment. Remove / attach the attachments by simply sliding
them off or onto the shaft of the motor unit.
Charging the battery
1. Turn off the device by setting the switch of the drive unit to 0.
2. Connect the mains adapter to the socket.
3. Connect the mains adapter to a certified wall socket. Charge the device for 14 hours
before first-time use.
NOTE:
• The indicator lamp lights up red during charging operation.
• The lamp does not indicate the charging status of the device.
• It is normal for the device to heat up during charging.
4. Stop any charging operation after a maximum of 14 hours.
CAUTION:
Always disconnect the plug from the wall socket after 14 hours of charging.
NOTE on battery life:
Observe the following in order to prolong battery life:
• Charge the battery only when it is almost empty.
• Charge the device at an ambient temperature between 0° and + 40° C.

Publicité

Table des Matières
loading

Table des Matières