Installation Clearance; Leveling; Stabilizing; Electrical Connection - KRATOS 69K-765 Manuel D'entretien, D'installation Et D'utilisation

FREEZER INSTALLATION (cont.)

Installation Clearance

69K-765
27 in
686 mm

Leveling

Ensure the floor where the unit is to be located is level.

Stabilizing

All models are supplied with casters for your convenience (refer to caster installation for mounting). It is very important,
however, that the cabinet be installed in a stable condition with the front wheels locked while in use. Should it become
necessary to lay the unit on its side or back for any reason, allow at least 24 hours before start-up to allow compressor oil
to flow back into place. Failure to meet this requirement can cause compressor failure and unit damage.
NOTICE:
Unit repairs will not be subject to standard unit warranties if due to improper installation procedures.

Electrical Connection

Refer to the amperage data on the Technical Information table, the serial tag, your local code or the National Electrical
Code to be sure that unit is connected to the proper power source.
DANGER
The unit must be turned OFF and disconnected from the power source whenever
performing service, maintenance functions or cleaning the refrigerated area. Failure to
comply may result in Death or Severe Personnel Injury.
2"
51mm
60.5 in
1537 mm
Max Door Swing
Clearance
69K-774
27 in
686 mm
Page 10 of 58
12" (305mm) clear space
60.5 in
1537 mm
Max Door Swing
Clearance