Publicité
Les langues disponibles
Les langues disponibles
Assembly Examples
Be sure to follow Safety and Assembly Instructions. Keep in mind the actual operation of your
machine and the effect it has on overall stability.
Direction of Roll
4. Select and arrange the Corners and the Side
Rails as necessary to assemble the base to
your machine's footprint. Position Side Rails
into corners as far as is practical.
a. Below is a standard arrangement, but
many different arrangements are possible.
You can use 1, 2, or 3 rails on either side.
b. To expand the functionality of this mobile
base on larger machine's, purchase
additional rails online at http://www.
boratool.com/rail-kit-w-hardware-
pm1000-htc2000
5. Bolt the Side Rails to the corners and each
other using these simple rules:
a. All connections require the use of (2) M6-12
bolts and (2) M6 nuts at each end of the
connections
Note: Insert bolts so that the nuts are on the
INSIDE of the mobile base.
6. Re-check dimensions with the tape
measure, then tighten all bolts and nuts. If
you are building a square configuration the
measurements between diagonal corners
should be relatively close.
A long, narrow base,
such as on a jointer,
would benefit from
this arrangement.
Most machines may
be arranged to the
convenience of the user.
5
A short, narrow base, such
as found on a drill press
or bandsaw, may benefit
Direction of Roll
from this arrangement. Due
to swivel rotation, base
may sit out of level. Rotate
swivel wheel away from
base to correct.
4 a
4 b
5
Publicité
