Zoef Robot Hendrik-Jan Mode D'emploi page 95

(1) Set Memory Point
---Separate the cutting area into 2~3 small areas according to the picture before use, then
set a suppositional memory point in each small area. The memory point will enable the
mower to leave its fence line and enter the certain small area to start mowing.
Put mower on fence wire with a maximum distance of 1 meter from charging station and make the
backside of the mower towards to charging station.
---Input password to show "AUTO" page.
--Press "MENU" to enter "SETTINGS" page, select " Set area
then press "OK".
---Enter "AREA" page, press "OK" to start the mower,
the mower walks counterclockwise on the fence wire.
Press "OK" when the mower moves to the first memory point. The mower will keep on moving, when
the mower moves to the second memory point, press "OK", when the mower move to the third
memory point, press "OK".
Please refer to the attached images for Memory point 1, 2, 3 separately.
Notice:
A) It is better to set the memory point in the middle of the line between two corners.
B) The best position of the memory point is on the fence line which passes the center of a small
area.
C) To ensure the mower walking smoothly, the max altitude difference between each two small
areas should not exceed 3cm. The minimum distance between two fence line
should be more than 50cm.
HO USE
",