Baby Trend HC05 AL Serie Manuel D'instruction page 8

OPERATION
TO REATTACH SEAT PAD
NOTE: Certain High Chair models are
packaged with the High Chair Seat Pad and
Seat Insert already attached to the Seat Back.
20) • Thread non-buckle end of Harness
Straps called Harness Attachment
Tabs through the provided slots in
the Seat Fabric, Seat Insert, Seat
Back, and Seat Base (Fig. 20). When
Harness Attachment Tabs are through
the provided slots, rotate the Harness
Attachment Tabs 90 degrees. Make sure
that the straps are firmly in place.
21) • Loop the flap on the back of the pad
over the top of the Seat Back. Connect
the Seat Pad to the Seat Back with the
two Elastic Loops. These fit over the
Attachment Tabs located near the top
harness slots (Fig. 21).
22) • Attach the bottom of Seat Pad to the
Seat Base with the two Elastic loops
located at the rear of the bottom of the
Seat Pad. These fit over the Attachment
Tabs located on the Seat Base near
where the Seat Back and Seat Base
Join (Fig. 22a).
13
Copyright © 2020, Baby Trend ® Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 20
TO REMOVE SEAT PAD
Reverse steps above.
OPTIONAL SEAT INSERT
23)
Fig. 21
Fig. 22a
• Attach each anchor hook of the Seat
Pad to the side of the seat armrest
(Fig. 22b).
• Ensure that the slot of the anchor hook
slides through the under side
division (Fig. 22c).
• Set Seat Insert onto Seat Pad.
See step 20.
Copyright © 2020, Baby Trend ® Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
OPERATION
Fig. 22b
Fig. 22c
Fig. 23
14