Baby Trend HC05 AL Serie Manuel D'instruction page 4

ASSEMBLY
3) • Slide the left and right sides' Height Bracket onto the Seat Base (Fig. 3a).
Lock the brackets in place (Fig. 3b).
4) • Slide the Footrest onto the Seat Base (Fig. 4). Lock Footrest into place.
5) • Insert the front tube of the right and left side Upper Frame Assemblies into
the Height Adjuster (Fig. 5). The front tube is easily distinguished from the
rear tube by the array of holes located on the backside of the front tube.
Height Bracket
Height Bracket
Fig. 3a
Fig. 4
5
Copyright © 2020, Baby Trend ® Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 3b
Upper Frame Assembly
Footrest
Release Handle
Height Bracket
Fig. 5
6) • Squeeze the Release Handles on both
sides simultaneously and push the tube
through the Height Adjusters until it locks
in the highest position (Fig. 6).
7) • Insert the Legs into the ends of the front
tube of both the right and left Upper
Frame Assemblies (Fig. 7).
NOTE: Legs are properly connected
when the lock buttons are lined up with
the holes on the ends of the Upper
Frame Assemblies. Make sure the lock
buttons are engaged before use.
8) • Insert another Leg into the ends of the
rear tube of both the right and left Upper
Frame Assemblies (Fig. 8).
NOTE: Legs are properly connected
when the lock buttons are lined up with
the holes on the ends of the Upper
Frame Assemblies. Make sure the lock
buttons are engaged before use.
Copyright © 2020, Baby Trend ® Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Release Handle
Fig. 6
Hole
Lock Buttons
Fig. 7
Hole
Lock Buttons
Fig. 8
6