Ancona Comfort 7 Manuel De L'utilisateur Et Instructions D'installation page 4

Step 3: Marking holes for wall mount posts (Fig. 3)
- Take towel warmer with four (4) Metal Wall Legs mounted, as per Step 2.
- Position against the wall where you will want to install the towel warmer.
- Ensure the Hard Wire Leg is also turned in at 90 degrees so you can also mark this leg.
- Use light pencil to mark legs on the wall (you may want to erase the pencil mark following installation completion, so make
sure you mark lightly).
Fig. 3
Step 4: Installing wall posts (Fig. 4)
If installing on dry wall with no rear beam support (e.g. wood studs):
o Drill a hole in the center of each of the four (4) circles marked on the wall as per Step 3.
o Ensure the drilled hole is large enough to insert the Plastic Plug provided a.
o Insert/screw the Plastic Plug into each of the four (4) holes.
o Position Wall Post b on top of Plastic Plug and put in Screw c to set in place.
If installing on surface with rear support, e.g. wood studs (no need for Plastic Plug a):
o Pre-drill small hole in the center of each circle as per step 3.
o Position Wall Post b on top of pre-drilled hole and put in Screw c to set in place.
Step 5: Installing hard wire leg (Fig. 5)
- Create a hole in the wall to let the Hard Wire Leg go through (approx. 2 in. x 3 ¾ in.).
- The leg will be covered by Plate h so the hole should be large enough to allow space for electrical connection and leg to go
through but not too large so that the plate can cover it fully.
- Electrical wiring must be done by quali ed professionals and in accordance with all applicable codes and standards, including
re-rated constructions (refer to Electrical Requirements on Page 2).
Step 6: Mounting main body onto wall (Fig. 6)
- Take main body and position each of the four (4) legs on top of the Wall Posts b.
- Once inserted use appropriate sized Allen key to tighten each Set Screw g.
- The installation should now be complete.
Step 7: Test the towel warmer
- Remove protective white caps, they are located at the end of each of the vertical bars.
- Turn the switch on to start towel warmer; the On-Off switch is located at the end of one of the posts.
- The towel warmer should reach its pre-set temperature in approximately 15 minutes.
- This towel warmer is designed to operate continuously and can be left on all the times. To save electricity it can be turned off
when not in use.
Hardwire Installation
Fig. 4
— 4 —
h
Fig. 5 Fig. 6