Ancona Comfort 7 Manuel De L'utilisateur Et Instructions D'installation page 3

55 cm 51,8 cm
(21.6 in.) (20.4 in.)
Parts for Hardwire Wall Mount Installation
a Plastic plug
4 + 1 pcs
Ø 8 mm
Wall Post
b
4 pcs
Screw
c
4 + 1 pcs
Step 1: Verifying installation parts (Fig. 1)
Ensure all parts for mounting installation were supplied with your towel warmer (See Fig. 1).
If any are missing, please contact us.
S e t p : 2 n I s a t l l n i g m t e
Locate the following parts:
o d: Metal Wall Leg.
o e: Large Screw to set post in main body (this part may already be installed inside the Metal Wall Leg).
o f: Plastic Insert (this part may already be installed inside the Metal Wall Leg).
o g: Set Screw (this part may already be installed inside the Metal Wall Leg) (See Fig. 6).
Position parts correctly:
o Plastic Insert f is positioned inside Metal Wall Leg d.
o Large Screw e is positioned inside the Plastic Insert f.
o Set Screw g is inserted in Metal Wall Leg d (See Fig. 6).
o If the Metal Post b is inserted into the Metal Wall Leg d, remove it.
Install Metal Wall Leg d:
o Position Metal Wall Leg d onto the towel warmer where the Large Screws e can be inserted.
o Insert Large Screw e and screw Metal Wall Leg d into main body using appropriate sized Allen key.
o Repeat for all four (4) Metal Wall Legs.
Product Dimensions
80 cm (31.5 in.)
7 cm 11 cm
(2.75 in.) (4.3 in.)
3.2 cm
(1.25 in.)
d Metal Wall Leg
4 pcs
Large Screw
e
4 + 1 pcs
Plastic insert
f
4 pcs
Hardwire Installation
l a w a l l e l g s ( i F . g ) 2
2.3 cm
(0.9 in.)
55 cm (21.6 in.)
g Set Screw
4 + 1 pcs
Plate
h
1 pc
Wall Plate Screws
i
2 + 1 pcs
— 3 —
1.3 cm (3.3 in.)
15 cm
(5.9 in.)
10.5 cm
(4.1 in.)
12 cm (4.75 in.)
j Small Allen Key
1 pc
Large Allen Key
k
1 pc
Fig. 1
Fig. 2