Niko 360-47000 Mode D'emploi page 19

360-47000
Read the complete manual before attempting installation and
activating the system.
1. DESCRIPTION
The Power Pack 360-47000 is designed for powering the daylight control
modules 360-4501x and can be used as stand alone power supply
for external sensors with NPN output. The power supply is provided
with three 10A relay contacts and is suitable for DIN rail mounting
(4U). The Power Pack is provided with a built-in overload protection.
The protection is reset after a power failure. The power supply can be
loaded with a max. of 1A.
2. INSTALLATION
Cabling:
230V AC part: min. 1.5mm
2
24V DC part (SELV): ±0.5mm diameter
3. OPERATION AND USE
Standard function
Power supply for the daylight control modules 360-4501x via the
RJ12-1 connector (and bus cable 390-40011). CH1, CH2 and CH3
to terminal range B cannot be connected. The daylight control module
switches relay contacts 1, 2 and 3.
Stand alone function
Stand alone power supply with relay function for sensors with an NPN
output (e.g. dualtech motion sensor 350-2011x). CH1, CH2 and CH3
EN 19