Ga.Ma Salon Exclusive PRO POWER 10-GH Mode D'emploi page 15

INSERTION OF COMBS:
The supplied combs have two snap on seats. One near the
teeth of each comb (Fig.1) and the other near the base of each
comb (Fig.2). To insert the combs in the hair clipper, set the
snap on base near the teeth of the comb on the hair clipper
blade and then push the base of the comb against the base of
the blade head until you hear a slight click: insertion will be now
be completed. Remove the combs using the tab located on the
base of the comb, exerting an outward force.
CUTTING LENGTH ADJUSTMENT:
PRO POWER 10 can be used for trimming and finishing touches, when used without attachment comb and
with the blade regulator on the main body, which features the following lengths: 0.3 mm, 1.05 mm, 1.8 mm,
2.55 mm and 3.3 mm. Otherwise, you can use the four attachment combs supplied to achieve a classic hair
cut to the following lengths: 3 mm, 6 mm, 9 mm and 12 mm.
CORD-CORDLESS FUNCTION:
This function makes it possible to use the hair clipper with and without the cord. If the appliance does not
have sufficient charge for use, it can be connected directly to the power supply without interrupting the
cutting in progress.
CLEANING AND MAINTENANCE:
A clean and properly lubricated hair clipper considerably improves its capacity and cutting precision.
DO NOT CLEAN ANY PART OF THE APPLIANCE UNDER RUNNING WATER.
CLEANING THE HEAD:
Before any cleaning operation, make sure that the appliance is properly turned off and disconnected from the
power outlet. Remove the accessory if it is inserted. Using the special brush supplied, remove any hair
residues between the blades and the back of the blade head.
NEVER DISASSEMBLE THE HEAD OF THE BLADE OR YOU WILL INVALIDATE THE WARRANTY ON
THE ENTIRE PRODUCT.
(Fig.1)
16
(Fig.2)