Maintenance; After Care And Cleaning; Customer Service Contact - Hoover BH90200 Guide De L'utilisateur

MAINTENANCE INSTRUCTIONS
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped
into water, call customer service at 1-800-406-2005 prior to continuing use�
This product contains no serviceable parts� Call 1-800-406-2005 for Customer Service�
WARNING:
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning or performing any maintenance.
WARNING:
Always wear eye protection with side shields or goggles marked to
comply with ANSI Z87.1. Failure to do so could result in fluids entering your eyes
resulting in possible serious injury.
WARNING:
When servicing, use only identical replacement parts. Use of any
other parts may create a hazard or cause product damage.
NOTICE: Periodically inspect the entire product for damaged, missing, or loose parts
such as screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts are replaced. Please contact
customer service or an authorized service center for assistance.
General Maintenance
Avoid using solvents when cleaning plastic parts� Most plastics are susceptible to damage
from various types of commercial solvents and may be damaged by their use� Use clean cloths
to remove dirt, dust, oil, grease, etc�
WARNING:
Do not at any time let brake fluids, gasoline, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can damage, weaken, or destroy plastic
which may result in serious personal injury.

AFTER CARE AND CLEANING

HOW TO DRAIN THE TANK:
If there is any liquid left in the tank after spraying, the tank should be drained before
cleaning�
1� Remove the battery pack�
2� Remove the motor housing from the tank by lifting up and releasing the latches on
each end of the unit
3� Drain the contents of the tank through the fill area�
NOTE: Drain the contents back into the original container� Do not store chemicals in the
tank�
WARNING:
Always store and dispose of chemicals properly. Disposal of
contaminated rinse water should be performed according to local ordinances and
bylaws. Draining the tank: If there is any liquid left in the tank after spraying, the tank
should be drained before cleaning.
HOW TO CLEAN THE TANK AND WAND ASSEMBLY:
1� Fill the tank about one-third full with clean water� A small amount of mild household
detergent may be added�
NOTE: Never use flammable chemicals or abrasive cleaning agents to clean the tank�
2� Wipe the outside of the tank with a clean, dry cloth�
3� Reattach the motor housing to the tank� Make sure the latches are closed�
4� Reinstall the battery pack� Spray until the tank has been emptied� Make sure to direct
the spray toward an area that will not be damaged by the spray solution�
5� Refill and repeat the procedure with clean water� It may be necessary to rinse the tank
more than once, then drain again as directed above�
6� Allow all pieces to completely dry before reinstalling parts and storing the unit�
6
CLEANING THE NOZZLE :
If the nozzle becomes plugged,
use the steps below to clear�
1� Remove the battery pack�
2� Unscrew and remove the
adjustable nozzle from the
spray wand�
3� Push a small wire through the
cross holes to clear any debris�
If necessary, rinse the cross
holes and nozzle with clean
water�
4� Wipe the nozzle and cross
holes with a clean dry cloth
and reinstall the nozzle�
REPLACING SEALS:
Over time, seals can harden and crack, which can allow the chemical sprayer to leak� A
set of replacement seals is included� Refer to the image shown for the location of each of
the seals, then replace as needed to address any leaks that develop�
Additional sets of replacement seals can be ordered by contacting customer service�
NOTE: Unthreading the connections to replace the seals could allow liquid to escape, so
always clean the chemical sprayer thoroughly as previously described before replacing
the seals�

CUSTOMER SERVICE CONTACT

If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped
into water, call customer service at ONEPWR Support prior to continuing use�
This product contains no serviceable parts� Call 1 (800) 406-2005 for Customer Service�