GYS GYSPRESS 8T Mode D'emploi page 15

STAMP AND CALIBRATE HOLES FOR FLOW-FORM RIVETS
If using Flow-Form rivets, it is necessary to pre-drill the metal before riveting. The stamping matrix above enables pre-
cise drilling and hole calibration for Flow-Form rivets.
After stamping, the punch is pushed into the metal to be
assembled. Then, it is necessary to swing the riveting
machine to release the punch and remove it from the
metal.
INSTALLATION OF FLOW FORM RIVETS
Before assembling metal sheets with Flow-Form rivets, it is necessary to pre-drill the metal (see
the procedure above).
GYSPRESS 8T
RESULT OF THE INSTALLATION OF SELF-PIERCING RIVET
EN
15