Télécharger Imprimer la page

Campbell Hausfeld CP5101 Instructions D'utilisation Et Manuel De Pièces page 9

Masquer les pouces Voir aussi pour CP5101:

Publicité

Les langues disponibles

Les langues disponibles

operation (continued)
ShutDoWn
1. Be sure all detergent is flushed from system.
2. Turn the motor OFF.
3 Turn the water supply OFF.
4. After the motor and water supply are turned off, trigger
the gun to depressurize the system.
NEVER turn the water supply off before
turning the engine/motor off. Serious
damage could occur to the pump and/or engine/motor.
NEVER disconnect the high pressure
discharge hose from the machine while
the system is pressurized. To depressurize, turn engine/motor
off, turn water supply off and squeeze gun trigger 2-3 times.
5. After each use, wipe all surfaces of the pressure washer
with a clean, damp cloth.
StoRaGE
• Do not store the pressure washer outdoors.
• Do not store the pressure washer where it might freeze
unless it has been properly winterized.
wINtERIzING INstRuctIoNs
1. Disconnect the high pressure hose from the pump.
2. Insert a 12 inch to 14 inch piece of garden hose into the
pump inlet.
3. Place a funnel in the other end of the garden hose.
Read the manufacturer's instructions for
safe handling and disposal of RV
antifreeze.
4. Pour approximately 6 oz. of RV antifreeze into the funnel.
5. Jog the On/Off Switch briefly until the RV antifreeze
comes out of the pump outlet.
6. Disconnect the high pressure hose from the gun and drain
the hose. Hold the gun and lance in a vertical position
and squeeze the trigger to drain the water out.
tIPS FoR ExtEnDInG thE lIFE oF youR PRESSuRE
WaShER
1. Never operate the unit without water.
2. Your pressure washer is not meant to pump hot water.
Never connect your pressure washer to a hot water supply
as it will significantly reduce the life of the pump.
3. Running the unit for more than one minute without
spraying water causes heat to build up in the pump.
Running the unit without spraying water can damage
pump components.
Maintenance
Observe regular maintenance intervals to ensure maximum
performance and life from the pressure washer. Refer to the
schedule for recommended maintenance. If you operate the
pressure washer in dusty conditions, perform maintenance
checks more often.
MaIntEnancE SchEDulE
MaIntEnancE SchEDulE
Daily
tEchnIcal anD conSuMER InFoRMatIon
vERtIcal oRIEntED PRESSuRE WaShERS
Pump Detergent Suction
Water to detergent ratio
Water Supply Requirements
Minimum inlet pressure
Maximum inlet pressure
Maximum inlet temperature
Minimum inlet flow rate
Inlet garden hose size
Maximum inlet garden hose
length
tEchnIcal SERvIcE
For information regarding the operation or repair of this
product, please call 1-800-330-0712.
REPlacEMEnt PaRtS InFoRMatIon
For information regarding where to order replacement parts,
call toll free 1-800-330-0712.
Please provide the following information:
• Model number
• Stamped code
• Part number and description
Address parts correspondence to:
Campbell Hausfeld
100 Production Drive
Harrison, Ohio 45030 U.S.A.
www.campbellhausfeld.com
MoDEl: cP5101
actIon nEEDED
Check water inlet screen
and filter.
10 to 1 (10%
detergent)
20 psi
100 psi
100˚ F
5 gpm
5/8 in. I.D.
50 ft
9

Publicité

loading