V 3.04
OPERATION INSTRUCTIONS
1.
Place the product upright on a flat, level, stable, heat-resistant surface, and then plug the
Power Cord into a standard 120-volt electrical outlet.
2.
Main Control Knob: Use this knob to set the heat setting (Figure B):
- Fan Only (no heat)
– Low Heat Setting (900 Watts)
– High Heat Setting (1500 Watts)
3.
Turn the Thermostat Control Knob clockwise to its maximum range (Figure B). ThePower
Indicator will illuminate, indicating the Heater is on.
4.
Allow the product to operate until the ambient room temperature reaches the desired
comfort level.
5.
Slowly turn the Thermostat Control Knob counter-clockwise until the product turnsoff. The
product will cycle on and off to maintain the setting.
6.
To adjust the thermostat, turn the Thermostat Control Knob towards maximum toincrease the
set ambient temperature and towards minimum to decrease it.
7.
Oscillation Switch: Use this switch to turn the oscillation function on and off (Figure B).
WARNING: Insure that no objects will be near the heater during the full range of
oscillation when using this function.
8.
Turn off the product by rotating the Main Control Knob to the "OFF" position, and then unplug
the product from the electrical outlet.
WARNING: Always unplug the product when it will be left unattended or not in use.
SAFETY PROTECTION SYSTEMS
This product has protection safeguards that shut off the product when parts become excessively hot or
if it tips over. If the product shuts off, immediately turn the Control to the "OFF" position and unplug it
from the electric outlet.
If overheated:
a.
Remove any objects near the product that may cause overheating. Use the product in a well-
ventilated area. Keep at least 3 feet (0.9 meters) of space on all sides of the product to allow
adequate air circulation.
b.
Allow the product to cool down for at least 10 minutes before plugging it back into an electric
outlet for re-use.
If tipped over:
Place the product on a flat, level, stable surface in order to prevent the product from tipping
over again.
TIP: Always install and maintain at least one smoke detector in good operating condition on each floor
of your home. Periodically check and/or replace the battery in your smoke detector with a new battery.
6
All manuals and user guides at all-guides.com
Ceramic Tower Heater
For technical questions call: 1-800-665-8685
8548737