Andis CLT-2 Mode D'emploi page 3

5. Plug charger directly into receptacle – do not use an
extension cord.
6. Unplug charger before plugging or unplugging appliance.
7. Keep the cord away from heated surfaces.
8. Never drop or insert any object into any opening.
9. Do not use outdoors or operate where aerosol (spray)
products are being used or where oxygen is being
administered.
10. Do not use this appliance with a damaged or broken blade or
comb, as injury to the skin may occur.
11. To disconnect turn control to OFF then remove plug from
outlet.
12. Use only Charger Model ZDJ035100US as supplied by the
manufacturer to recharge.
13. Children should be supervised to ensure that they do not play
with the appliance.
14. WARNING: Keep the appliance dry.
15. THIS PRODUCT INTENDED FOR HOUSEHOLD AND
INDOOR USE ONLY.
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
(Refer to Figure A unless noted).
Before starting your trimmer, it must be pre-charged fully before using it for the first time.
To start trimmer, slide the power switch up; to stop, slide switch back to original position.
Switch marking "0" means OFF and "1" means ON.
UNIVERSAL AC/DC POWER ADAPTER
The unit is equipped with a universal AC/DC power adapter.
CHARGING TRIMMER
This battery charger is intended for use with Andis model CLT-2 trimmer. Remove the
trimmer and AC/DC adapter from the carton. Plug the adapter into a 120V AC outlet, or
according to your local power standards. Confirm the voltage available at each overseas
location before using the appliance. For connection to a 240V supply, use an attachment
plug adapter of the proper configuration for the power supply receptacle.
3