Baby Trend RC87 Manuel D'instruction page 8

ASSEMBLY
TO ASSEMBLE CHANGING TABLE
ATTENTION: Playard and large bassinet must
be fully assembled and securely locked before
installing or using the changing table feature
(See To Assemble Playard and large bassinet
sections, pages 2 - 9).
14) • Connect the two Long Curved Bars
together (Fig. 14a).
• Insert the assembled curved bars into the
outer sleeve of the Changing Table fabric
(Fig. 14b). Slide the Curved Bars around
inside sleeve of the Changing Table.
• Connect the two Short Bars to each end
of the Long Curved Bar (Fig. 14c). Make
sure that the knobs are both facing down
and the same direction on each end (Fig.
14d).
15)
• Insert Connector Knob Prongs into holes
located on both corners of the Playard
(Fig. 15a).
• Turn the Connector Knobs counter
clockwise to lock into place (Fig. 15b).
• Flip Changing Table over onto Playard
(Fig. 15c).
• Secure the two snaps on the flap down
onto the Playard (Fig. 15d).
13
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
TO ATTACH THE CHANGING TABLE TO THE PLAYARD
Fig. 14a
16)
• Locate the hook and loop fasteners on the bottom of the changing table and
on the inside of the side rails of the playard (Fig. 16).
IMPORTANT!
position the changing table must be secured to the playard frame using the
hook and loop fasteners provided.
Fig. 14b
17)
• Flip the changing table into its upper position (Fig. 17).
18)
• Secure the changing table to the playard frame by fastening the hook and
loop fasteners on the underside of the changing table to the side rails of the
playard frame (Fig. 18).
Fig. 14c
Fig. 14d
Fig. 15a
Fig. 15b Fig. 15c
When the changing table is flipped up into the upper
Fig. 16 Fig. 17
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 15d
Fig. 18
14