Publicité
Les langues disponibles
Les langues disponibles
6. Set the measured water depth at the scale.
7. Process the electrical connection to the display unit.
8. Ready for start-up.
Preliminary Installation:
The tank electrode is designed for vertical installation from the tank top.
Contrarily to waste water and faecal
tanks (deposit), an installation at the lower side of the tank is also possible.
The tank electrode should be placed at the topmost location and in the tank centre. Mounting hole, diameter
38mm, or thread PG29.
Depending on the local conditions (available space above the tank, cutout of the intermediate floor, tank height
etc.), the tank transmitter can be installed at the tank inside or outside (for the short type tank electrode MT TK
is for best results, if possible, the installation outside recommended):
Inside-/ Outside Installation
The two stick probes must be shortened to identical length (metal saw, strong side cutter, bolt cutter).
It is important, that a clearance of at least 10 - 20 mm is left between tank bottom and probe ends (deposit, up-
and-down movement of the tank bottom and of the tank top during driving etc.)
Burr the sticks, and reinsert the insulating cap on the stick probe being insulated by the plastic pipe.
A thorough sealing between the insulating cap and the plastic pipe is decisive for proper operation of the tank
sensor !
2
Publicité
