Publicité
Les langues disponibles
Les langues disponibles
NOTE: a blue LED will flash quickly when the T312 power case is low on battery & requires recharging
Earbuds:
a) Place T312 earbuds into the charging slots
b) Push switch to the
c) Red LED on Multi-Function button of T312 earbuds indicate the device is charging (a solid Blue LED will
appear on both earbuds and will automatically stop charging once both earbuds are fully charged)
d) To manually stop charging, simply remove both earbuds or push switch to the
power OFF
NOTE:
-
if red LED on T312 earbuds do not appear while charging in charging slot, lightly push the earbuds down to align
the earbuds & power case in charging position
-
a red LED will flash quickly & a short melody will be prompted when the T312 earbuds are low in battery &
requires recharging
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
icon to power ON
icon power case to
Publicité
