Spector&Co SPECTECH T312 Mode D'emploi page 3

flashes BLUE twice. Earbuds is now in STANDBY mode.
b) OFF: press & hold the Multi-Function button on both true wireless earbuds for 4 seconds until the LED light
on both earbuds flash RED
NOTE: previously paired devices will automatically connect to the T312 earbuds when turned on. Both earbuds of
T312 will power off automatically after 10 minutes if not used in standby mode
2. T312 Wireless Pairing
a) Remove the earbuds from the power case.
b) Press & hold Multi-Function button on both true wireless earbuds of T312 for 5 seconds until a blue & red
LED light flashes
c) The T312 earbuds must be paired manually. Press the button on one earbud twice & the T312 earbuds will
be paired to each other within 5 seconds. NOTE: once you press the button on one of the earbud twice,
the T312 will also designate the earbud as the Primary earbud
d) Flashing blue LED on each earbuds indicate that the T312 has been successfully paired to your audio
device. (NOTE: once the T312 true wireless earbuds are paired to each other, the T312 will assign
wireless functions between the T312 primary & secondary earbuds – there are no pre-assigned left or right
sides)
e) Enable Bluetooth function on your electronic device. Search Spector T312 & pair the devices (blue LED
will flash once every 10 seconds when successfully paired)
f) To DISCONNECT from Wireless pairing, press & hold Multi-Function buttons on one of the earbuds until
LED light is power OFF.
*** NOTE: once paired to your audio device, the T312 Primary true wireless earbud will flash blue LED
quickly, while the T312 Secondary true wireless earbud will flash blue LED slowly.
3. T312 Operation in Wireless Mode
a) Answer/End calls & Play/Pause function: press once on the multi-function button of the T312 Primary
earbud
b) Skip songs: press once on the multi-function button of T312 secondary earbud
c) Previous songs, volume control & redial/reject incoming calls must be controlled directly from your audio
device
NOTE: although each earbud has a built-in microphone, only the microphone on Primary earbud can be used once
both earbuds are paired.
4. To Charge the T312
Power case:
a) Insert provided micro USB into the charging dock of the T312 & plug the USB into a certified wall adapter
(not included)
b) A solid red LED indicates the device is charging (a solid blue LED will appear once fully charged)
c) To stop charging, remove the micro-USB/USB charging cable from the T312