Publicité
Les langues disponibles
Les langues disponibles
• Do not touch the front part of the appliance, it might reach hot tempera-
ture.
• To prevent a possible fire, do not block air intakes or exhaust in any man-
ner. Do not use on soft surfaces, like a bed, where openings may become
blocked.
• A fan heater has hot or arcing or sparking parts inside. Do not use it in
areas where gasoline, paint, or flammable liquids are used or stored.
• To prevent overload and blown fuses, be sure that no other appliance is
plugged into the same outlet (receptacle) or into another outlet (recepta-
cle) wired into the same circuit.
• Use the heater only under supervision.
• Do not insert any object and/or finger into the openings of the heater.
• To extinguish burning appliances only use fire blankets.
• It is normal for the heater's plug and cord to feel warm to the touch. A plug
or cord which becomes hot to the touch or becomes distorted in shape
may be a result of a worn electrical outlet (receptacle). Worn outlets or
receptacles should be replaced prior to further use of the heater. Plugging
heater into a worn outlet/receptacle/ may result in overheating of the
power cord or fire.
• This heater is not intended for use with an extension cord. Plug the cord
directly into an appropriate wall receptable.
• Be sure that the plug is fully inserted into an appropriate receptacle.
Please remember that receptacles also deteriorate due to aging and con-
tinuous use: check periodically if signs overheating or deformations are
evidenced by the plug. Do not use the receptacle and CALL your electri-
cian.
• Check that neither the appliance nor the power cable have been damaged
in any way during transportation.
• CAUTION: to prevent electric shock match wide blade of plug to wide
slot, fully insert.
• Always use the heater in an upright position.
• Do not use the appliance close to walls, furniture, curtains etc.
• Do not cover the appliance when in operation as this could cause over-
heating and a possible fire.
Setting up / operation
Note: Make sure that there is always sufficient space between the appli-
ance and the wall or other large objects (> 20 in / 50 cm). The air flow must
not be blocked by objects of any kind.
1. Having set up Paul in the desired position connect the cable (1) to the
household supply socket.
2. First, push the main switch for power supply (4) on the back of the ap-
pliance.
3. Switch on the appliance by pressing the On/Off button (6). The target
temperature appears on the display.
4. The target temperature can be changed from 32 °F / 0 °C (cooling mode)
to 80 °F / 26°C or maximum «Hi» by making a vertical sliding movement
across the right-hand control panel for selection of temperature (8)
«Temperature». The heating mode is active from 33 ° – 80 °F / 1 °C –
26 °C & «Hi». The digit flashes in configuration mode. Making a sliding
movement upwards or typing «+» in the upper field increases the target
temperature. Making a sliding movement downwards or typing «–» in
Publicité
