Pepperl+Fuchs DA5-IU-C Caractéristiques Techniques page 12

DA5-IU-C
1 Safety instructions and warnings
Use this display only
– in compliance with its intended
!
purpose
– if its technical condition is perfect
– in accordance with the operating
instructions and the general safety
provisions.
1.1 General safety instructions and
warnings
1. Before carrying out installation or main-
tenance work, make sure that the device is
disconnected from the power supply.
2. Use this digital display only in compliance
with its intended purpose: if its technical
condition is perfect and in accordance with
the operating instructions and the general
safety provisions.
3. Comply with the country and applicati-
on-specific provisions
4. This digital display is not suitable for use
in areas with explosion protection and for
areas excluded in EN 61010 part 1.
5. This digital display must only be operated
when properly mounted in a panel in accor-
dance with the section "Technical Data".
6. The device must compulsorily be protected
with approved external fuses. The value of
these fuses can be found in the technical
information.
1.2 Use according to the intended purpose
This digital display may only be operated as a
built-in device. The application area for this
display device lies in industrial processes and
controls, in the fields of manufacturing lines for
the metal, wood, plastics, paper, glass, textile
and other like industries. Over-voltages at the
terminals of the device must be kept within the
limits of Over-voltage Category II. If the digital
display is used to monitor machines or pro-
cesses in which, in the event of a failure of the
display or an error made by the operator, there
Page 2 (R60046.9398 - Index 1)
might be the risk of damaging the machine or
causing an accident to the operators, it is your
responsibility to take the appropriate safety
measures.
1.3 Description
• Digital 5-digit display with analog inputs
• Easily readable, bright 8 mm high LED
display
• Display range from -19999 to 99 999 with
leading zero blanking and programmable
decimal point
• The functions and operating parameters are
programmed by means of the two setting
keys.
Operator guidance on the display during the
programming routine
• The following parameters are programmable:
Measuring range
Measuring time
Decimal point measured value
Minimum input signal
Value to be displayed for the
lowest input signal
Maximum input signal
Value to be displayed for the
highest input signal
Minimum value display yes/no
Minimum value reset
Maximum value display yes/no
Maximum value reset
Totalizer yes/no
Decimal point totalizer
Multiplication factor totalizer
Scaling totalizer
Totalizer reset