Frequently Asked Questions - Inventum PJ010 Mode D'emploi

CLEANING OR REPLACING THE HEPA FILTER
The HEPA filter cleans the air one last time before it leaves the vacuum cleaner. Clean the HEPA filter at least
once per six months or when it is very dirty. Replace a damaged HEPA filter with a new original HEPA filter.
• Open the grid [23] that covers the HEPA filter by pushing the clip.
• Pull the clip back and take out the HEPA filter [24].
• Rinse the HEPA filter under lukewarm water and let it air dry completely. Do not use any cleaning agents
or brushes.
• Put the HEPA filter back into place, when dry, or replace it by a new one.
• Replace the grid. Make sure that the grid is properly placed.
Attention
• Use the vacuum cleaner only when the filters and a dust bag are in place. If not, it can lead to loss of
suction power or damage to the motor.
• Unplug the vacuum cleaner before cleaning or replacing the filters.
• Torn filters or filters that do not fit properly can cause damage to the engine. Replace a damaged filter by
an original new one.
• Do not clean the filters in a dishwasher.
• Do not use a hair dryer to dry the filters.
STORAGE
For easy storing the vacuum cleaner.
• Rewind the cord by pressing the cord rewinding foot pedal
• Push the slide button on the telescopic tube upwards and push the telescopic tube together to make it
shorter. Release the slide button and let the tube snap into place.
• Park the vacuum cleaner and slide the floor nozzle in the attachment at the back of the device [25].
7

frequently asked questions

Problem
The suction has decreased.
It is hard to move the brush over
the surface.
The vacuum cleaner makes
more noise.
18
• English
Possible cause
The dust collector is full.
The filters are clogged.
The button for the suction power is not set
to max or the extra suction power control
on the handle is open.
The suction power is set too high.
The button on the brush is set on the wrong
setting.
The tube or hose is clogged.
The motor filter or HEPA filter is clogged.
The cyclone system is clogged.
.
Solution
Empty the dust collector.
Replace the motor filter for a new one or clean
the HEPA filter according to the instructions.
Set the suction power to maximum or close the
control for extra suction power on the handle
of the hose.
Decrease the suction power or open the extra
suction power control on the handle.
Make sure the brushes are retracted on carpet.
Make sure the brushes are down on a hard floor.
Disconnect the tube and the hose and empty
them.
Replace the motor filter.
Clean or replace the HEPA filter.
Empty the dust collector and clean the cyclone
system according to the instructions.
23
24
25