Publicité
Les langues disponibles
Les langues disponibles
EN
Fig. 11
Side panel
Front angle
clamp
Flat
washer #2
Hex nut
12. Repeat steps 8 – 11 to assemble the other side panel.
13. Lay the cart box in the upright position. Remove the front
panel by sliding it up and remove the four #1 flat washers
used as shims (Fig. 12).
Fig. 12
Front
panel
14. Assemble the supporting tube using four M6 x 50 screws
and #2 flat washers through the side panels and the
supporting tube. Secure with #2 flat washers and handle
knobs (Fig. 13).
M6 x 25
screw
Flat
washers
#1
Fig. 13
Flat washer #2
M6 x 50
screws
Flat washer #2
15. Place the handle tube over the side panels and line up
the four holes. Assemble using four M6 x 50 screws and
#2 flat washers through the side panels and handle tube.
Secure with #2 flat washers and handle knobs (Fig. 14).
Fig. 14
M6 x 50
screws
Flat washer #2
16. Lay the cart upside down. Slide the axle through the axle
clamps (Fig. 15).
6
Supporting
tube
Flat washer #2
Handle
knobs
Handle
tube
Flat washer #2
Handle
knobs
Publicité
