Küchenprofi STYLE Mode D'emploi page 17

Use
Cooking rice
1. Measure the rice with the measuring cup, wash the rice as needed
and add it to the pot with non-stick coating. dd the liquid up to the
mark on the inside of the pot.
1 Measuring cup of rice - fill with liquid up to 1 CUP mark.
2 Measuring cup of rice - fill with liquid up to 2 CUP mark.
ttention: The 10 CUP mark in the pot must not be exceeded.
2. Check to ensure that the non-stick pot is seated correctly in the heating
bowl and close the lid.
3. Connect the cable to the appliance and insert mains plug in a suitable
socket.
4. If all of the control lamps are blinking, select the desired program.
Then the relevant control lamp blinks and the time appears in the
display. fter a few seconds, the control lamp and the time illuminate
continuously and the appliance begins cooking.
Note: If you have not made a selection within 15 seconds, the
appliance switches off. Press the ST RT / W RM button to switch on
the appliance.
5. The cooking time presetting of 45 minutes is shown in the display.
However, this can vary depending on the amount of rice and liquid.
Empty the condensate container on the back side of the appliance as
needed.
6. signal tone is sounded when the rice is finished cooking. Then the
cooker switches automatically to a lower temperature to keep the rice
warm. The time that this mode has been active is displayed, up to a
maximum of 12 h. fter 12 hours, the appliance switches off
automatically.
TIPS:
· The indicated ratio between the food and liquid is a guidelines value
which can be adjusted as needed. Vary this ratio according to your
taste. Further information is also provided on the food package.
· For creamier rice, we recommend keeping the rice warm for 10 - 15
minutes after the cooking process is finished.
Cooking risotto
1. Measure the risotto rice with the measuring cup and add it to the pot
with non-stick coating. dd the liquid in a 1:3 ratio.
1 measuring cup of rice - 3 measuring cups of liquid
ttention: The 10 CUP mark in the pot must not be exceeded.
2. Check to ensure that the non-stick pot is seated correctly in the heating
bowl and close the lid.
3. Connect the cable to the appliance and insert mains plug in a suitable
socket.
4. If all of the control lamps are blinking, press the RISOTTO button. Then
the relevant control lamp blinks and the time appears in the display.
fter a few seconds, the control lamp and the time illuminate
continuously and the appliance begins cooking.
Note: If you have not made a selection within 15 seconds, the
appliance switches off. Press the Start / Warm button to switch on the
appliance.

D G B
17