Blumfeldt Arizona Rust Mode D'emploi page 26

EN
26
Re-ignite Fire
Before refilling the fireplace with fuel, observe the following:
• Extinguish the burner with the extinguishing tool supplied or allow the
fuel to burn out completely. Allow the unit to cool for 30 minutes before
refilling with fuel.
• Wait until the fireplace and burner have cooled down to room
temperature. The remaining flame may be difficult to see. Make sure that
the flame is extinguished and that the fireplace no longer emits heat.
• Fill the burner only to the maximum mark. Do not overfill it.
• Light the fuel with a fireplace lighter. Keep face and body away from the
fireplace during ignition. The flame begins to flicker slowly. The flame may
initially be low and almost invisible, allow the flame 15 minutes to reach
the optimum level.
• Never leave a burning or hot fireplace unattended. Keep children and pets
away from the fireplace.
Note: Ethanol fuel may cause serious burns, property damage or even
death if used improperly and unsafely. Do not dispose of burnt fuel. Dispose
of unused fuel and empty fuel bottles in accordance with local hazardous
materials regulations. We recommend that you always burn all the fuel in
the burner.
CLEANING AND CARE
• The fireplace and reservoirs must be cleaned regularly. Use warm water
and soap.
• Marks can be best removed with a soft cloth and a mixture of lukewarm
water and a small amount of soap. We recommend cleaning the stainless
steel regularly to prevent contamination.
• Do not put the water inside the burning tank, as the ceramic wool inside
will absorb the liquid.
Note: Never use chemicals, steel-wool or scrubbing sponges as stainless
steel surface can be scratched by these items. The manufacturer will not be
held responsible for any damages resulting out of false use and/or cleaning
of the product.