Stanley STHT77587 Mode D'emploi page 5

Contents
• Stud Sensor Information
• User Safety
• Battery Safety
• Installing AAA Batteries
• Using the Stud Sensor
• Maintenance
• Troubleshooting
• Service and Repairs
• Warranty
• Specifications
Stud Sensor Information
The Stud Sensor STHT77587/STHT77588 uses electronic
signals to locate the center of wood or metal studs, or live AC
wires through drywall or other common building materials.
PLEASE NOTE:
• The stud sensor will not detect objects in concrete, mortar,
block, brick work, plaster, carpeting, foil- faced materials,
metallic surfaces, or ceramic tile.
• The stud sensor is not designed to locate non-ferrous or
plastic objects, such as pipes.
Once the center of a wood or metal stud has been detected
in one pass across the surface, the Stud Sensor STHT77587/
STHT77588 turns on an LED and sounds an audible tone.
A marking hole allows you to easily note the stud center.
EC-Declaration of Conformity
Stanley herewith declares that the product STHT77587/
STHT77588 is in compliance with the essential requirements and all
other provisions of Directive 1999/5/EC.
The full text of the EU Declaration of Conformity can be
requested at Stanley Tools, Egide Walschaertsstraat 14-16,
2800 Mechelen, Belgien, or is available at the following internet
address: www.2helpU.com.
User Safety
Safety Guidelines
The definitions below describe the level of severity for each
signal word. Please read the manual and pay attention to these
symbols.
WARNING: Indicates a potentially hazardous
situation which, if not avoided, could result in serious
injury.
CAUTION: Indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate
injury.
NOTICE: Indicates a practice not related to personal injury
which, if not avoided, may result in property damage.
If you have any questions or comments about this or any
STANLEY tool, go to www.2helpU.com.
®
WARNING:
Read and understand all instructions. Failure to
follow the warnings and instructions in this manual
may result in serious personal injury.
SAVE THESE INSTRUCTIONS
WARNING:
The following label information can be found on your
tool for your safety.
WARNING:
If the equipment is used in a manner not specified
by the manufacturer, the protection provided by
the equipment may be impaired.
CAUTION:
Protect your eyes. Wear safety goggles.
Made in China
AAA
Made in China
AAA
GB
5