AGV K-3SV Mode D'emploi page 14

3) INTERNAL COMPONENTS
14
1
CLICK!
3
3
Crown pad
Cheek pads
Wind-proof chin strap protection
3.1) Removing/fitting cheek pads
To remove the cheek pads, hold them in front near the
chin guard and pull them in the direction of the arrow
to free them from the press studs (1). Slide the plastic
flap out of its position and remove the cheek pads (2).
To refit the cheek pads, slide them into the helmet and
fasten them into place with the press studs (3). Slide
2
the plastic flap into position
on the side of the helmet (4).
Make sure that the cheek pads are properly fastened
to the helmet.
4
4