Publicité
Les langues disponibles
Les langues disponibles
WARNING: The welding helmet should be adjusted to ensure it is positioned over the eyes and
General Operations
1. The sensitivity control is designed to make the filter lens more responsive to different light levels.
Use toggle switch to adjust as required for application.
2. The delay control is used to adjust the hold time of the filter lens after welding is completed. Use
toggle switch to adjust as required for application.
3. Variable Shade Control - The shade number can be set from 9 to 13 by turning the shade control
knob until the arrow points to the desired shade number and/or toggle switch.
Care and Maintenance
• Keep the sensors and solar cells clean. Clean the filter cartridge using a soapy water solution and
soft cloth which should be damp but not saturated.
• Do not use solvents or abrasive cleaning detergent.
• Replace parts with only genuine Forney
• Do not immerse the filter in water.
WARRANTY INFORMATION: Reference www.forneyind.com/support/warranty-information
PROBLEM
Auto-darkening filter lens flickers and/or
does not darken
Auto-darkening filter lens will not turn ON Batteries are low or dead
Auto-darkening filter lens turns dark
when others are welding nearby
Irregular darkening or dimming
Viewing Area
Variable Shade Selection
Shade Selector
Grind Mode
Number of Arc Sensors
Optical Clarity Rating
Shell
Sensitivity Control Adjustment Low-High, Internal, adjust by switch button
Delay Control Adjustment
Switching Speed
Low TIG amps rated
Power Supply
Meets Standards
face to ensure adequate protection
replacement parts.
®
TROUBLE SHOOTING
POSSIBLE CAUSE
Sensors are blocked
Front cover lens is dirty
Sensitivity is set too low
Sensitivity is set to high
Headband has been set unevenly on
both sides of helmet (unequal distances
from the eyes to filter's lens)
TECHNICAL SPECIFICATIONS
5.97 Sq in.
DIN 9 to 13
External shade selector knob
None
2
1/1/1/2
Lightweight (16.57 oz), impact resistant, fireproof
Low-High, Internal, adjust by switch button
1/25,000 per second
5 AMP
Solar cells with 2-each non-replaceable 3V lithium batteries and automatic on/off technology
All related CE standards (DIN and ISO), and ANSI Z87.1 safety standards
WWW.FORNEYIND.COM
SOLUTION
Clean the sensors with a soft cloth
Clean cover lens with a soft cloth. Replace if necessary
Adjust the sensitivity switch/knob.
Try replacing both batteries with new batteries, then
check the low battery indicator
Reduce sensitivity
Reset headband to reduce difference in distances to
filter, if necessary
4
Publicité
