Preparing The 2 Conductor Burial Cable - Martin Logan OUTDOOR LIVING FOUNDATION Serie Mode D'emploi

Preparing the 2 Conductor Burial Cable (For Mono Setup)
1 . Starting with the
first speaker and
every speaker/
sub that comes
after, create a
loop approximate-
ly 6" in length .
3 . Use a round
cable stripper to
remove the outside
protective cable
jacket to expose
the two color-
coded wires .
Separate the
wire loops
as shown .
red (+) black (-)
2 . Recommended:
Use a wire tie
(not included) to
keep the wire
loop intact and
it will act as a
strain relief .
4 . Cut the red (+)
and black (-)
wires with cable
strippers and
strip off 1 inch
(25 .4mm) of
insulation to
expose the bare
wire conductor .
EN |
10