Publicité
Les langues disponibles
Les langues disponibles
ROUGH-IN PLATE
4.
Remove wiring cover.
5.
Connect power cable to wiring box using proper connector.
Connect Black to Black (hot), White to White (neutral) and
Green or Bare wire (ground) under second ground screw.
Replace wiring cover.
6.
Run 8" round steel duct to installation location.
7.
Connect duct to damper. Seal using duct tape to make all
joints secure and air tight.
8.
Plug blower power cord and rough in plate power cord into
hood receptacles
9.
Wrap wires with wire tie (provided).
BLACK TO BLACK
WHITE TO WHITE
GREEN TO GREEN
OR BARE WIRE TO
GROUND SCREW
MODEL P6
Page 4
Publicité
