Using The Appliance - MACAP MLYNEK M5D C10 Manuel De L'utilisateur

conformity with safety regulations in the country of
installation. Special attention must be paid to legal
requirements, accident prevention, fire prevention
and regulations issued by the electricity company.
Place the appliance on a flat surface where it is
perfectly stable; fix the coffee hopper to the
adjustment nut using the supplied screw, to prevent
any moving parts being accessible when it is being
used. The screw must be put into the threaded hole
in the upper grinder support and the hole in the
coffee hopper (see fig. 2). Before connecting the
appliance to the electricity, check it is turned off
(switch on 0) and that the voltage and frequency
given on the serial plate corresponds with the
electrical standard available. The power socket must
be connected to an efficient ground bar that
conforms to current safety regulations in force.
6

USING THE APPLIANCE

Check the coffee hopper is correctly fixed and stable on the upper grinder support,
and then put the coffee beans in. Put the lid on the coffee hopper and open the coffee
hopper fan so that the coffee beans can fall into the grinding section:
6-1 First start-up
Press the main switch to turn the machine on (position I). When the appliance starts,
the display shows a short message. After a few seconds one of the set functions
appears in English (Single dose – Double dose).
To change from one function to the other, press the control disc above the display
(blue). Place the filter holder on the fork and press the red dosing button, to start
grinding for the selected time shown on the display. When the grinding is finished, you
can remove the filter holder and then press and make the coffee.
6-2 Language selection
The appliance has 5 display languages: Italian, French, German, English and Spanish.
To change the language, turn the machine on; once the opening message appears,
you can enter the programming mode by pressing the control disc for 10 seconds or
until the wording on the display changes. Scroll through the menu by turning the
control disc until the word "Language" appears, press the disc to enter the language
selection. Turn the disc to change the language and press it to confirm. Scroll through
the menu by turning the control disc and select "Exit" to leave the programming mode.
The messages will now appear in the selected language.
6-3 Grinding regulation
To change the grinding coarseness, turn the regulation nut beneath the hopper. If the
nut is turned in a clockwise direction the beans are ground courser, or ground finer in
the opposite direction. If the coffee comes out of the machine slowly, it means that it is
too fine, but if it comes out too fast it is too coarse. Various factors have an effect on
the speed the coffee comes out, such as the amount of coffee, the pressing, the
regulation of the espresso machine, the cleanliness of the filters and the environment
8
ENGLISH