Operating Instructions - Dexter power J1G-ZP1A-210D Notice De Montage - Utilisation - Entretien

8. OPERATING INSTRUCTIONS

Be sure the supply is the same as the voltage given on the rating plate. Remove
Important:
the mains plug before carrying out any adjustment or servicing.
ASSEMBLY
To prevent the accidental starting that could cause possible serious personal injury,
Warning:
ALWAYS assemble all parts to you saw BEFORE connecting it to the power supply. The saw
should NEVER be connected to a power supply when you are assembling parts, making
adjustments, installing or removing blades, or when not in use.
DUST EXTRACTION PORT
can be achieved by clipping a dust bag on the Dust extraction port (22).A dust bag is provided
upper blade guard.
To empty the dust bag,remove it from the dust exhaust port,open the dust bag by unzipping
the slide fastener.
NOTE:
approximately 2/3 of its capacity.
TRANSPORTATION
and the plug is removed from the power point.
Only lift the saw by the operating handle (3) or outer castings. Do not lift the saw using the
guards.
BENCH MOUNTING
To ensure that the mitre saw is always stable and secure.The saw base has holes in each
corner to facilitate bench mounting.
the saw to the bench using 4 bolts.
2. If desired, you can mount the saw to a piece of 1/2" (13 mm) or thicker plywood which can
then be clamped to your work support or moved to other job sites and re-clamped.
CAUTION! Make sure that the mounting surface is not warped as an uneven surface can
cause binding and inaccurate sawing.
158
FR
ES
PT
IT
EL
EN