Dexter power J1G-ZP28-255A-EU Notice De Montage - Utilisation - Entretien page 165

FR
13. Loosen the Phillips head screw holding the pointer of the bevel scale (11) and
ES
adjust the position of the pointer so that it accurately indicates zero on the scale.
Retighten the screw.
14. Retighten the bevel lock (10) and the lock nut securing the 0° bevel adjustment screw
PT
(27).
IT
SETTING THE FENCE SQUARE WITH THE TABLE
1. Make sure that the electrical plug is removed from the power point.
2. Push the saw arm (1) down to its lowest position and engage the release knob (2) to
EL
hold the saw arm in the transport position.
3. Loosen the mitre locks (18) and lifting up the mitre latch (19).
EN
4. Rotate the table (14) until the pointer is positioned at 0°.
5. Release mitre latch (19) and tighten the mitre locks (18).
6. Using a 5 mm hex key, loosen the two screws securing the fence (12) to the base.
7. Place a square against the fence (12) and alongside the blade.
8. Adjust the fence (12) until it is square with the blade.
9. Tighten the screws securing the fence (12).
10. Loosen the Phillips head screw holding the pointer of the mitre scale (15) and adjust it
so that it accurately indicates the zero position on the mitre scale.
11. Retighten the screw securing the mitre scale pointer.
CHANGING A BLADE
1. Make sure that the electrical plug is removed from the power point.
2. Match the arrow on the blade with the arrow on the upper blade guard. Make sure that
the blade teeth are pointing downward.
3. Push down on the operating handle (3) and pull the release knob (2) to disengage the
saw arm (1).
4. Raise the saw arm (1) to its highest position.
5. Loosen the cover plate screw about 2 turns with a Phillips screwdriver. Do not remove this
screw from the tool.
6. Pull the rotating blade guard (6) down. When the rotating blade guard (6) is positioned
7.Lift and hold up the rotating blade guard (6) to expose the threaded blade bolt.
8 Hold the rotating guard (6) up and press the spindle lock button (20). Rotate the blade
until the spindle locks.
9. Use the 6 mm hex key provided to loosen and remove the blade bolt. (Loosen in a
clockwise direction asthe blade screw has a left hand thread).
11. Wipe a drop of oil onto the inner blade washer and the outer blade washer where they
contact the blade.
161