Technical Data - Roto ZEL STG LSF II Mode D'emploi

b. Programming the master transmitter (hand-held transmitter)
Press the programming button on the master transmitter whilst in Program-
ming mode until the receiver confirms that programming was successful (sig-
nal tone, jerk, LED, etc.).
Deleting the receiver's programming
Press and hold down the M1 and M3 buttons on the control unit until the LED
lights up continuously. This will clear all the programmed transmitters.
► The receiver can now be reprogrammed.
Programming additional transmitters (radio light
sensor)
1. Press the programming button of the master transmitter until the re-
ceiver confirms.
2. Then press the programming button of the new transmitter until the re-
ceiver confirms.
3. Now press the programming button of the new transmitter again.
4. The receiver confirms successful programming.
Rated voltage
Battery type
Degree of protection
Permissible ambient temperature
Radio frequency
The maximum radio range on and in the building is up to 10 m, and up to 100
m in the open.

Technical data

3 V DC
CR 2032
IP 20
0 to +55 °C
868.3 MHz
27 - en