Publicité
Les langues disponibles
Les langues disponibles
Installing attachments
If you wish to install the fabric brush or steam bonnet attachments, hold
the handle and use the other hand to clip on the fabric brush or steam
bonnet onto the ironing head. See picture below for reference.
NOTE: The fabric brush is used to brush out wrinkles and dust while the
steam bonnet filters water from impurities and for added drip
protection.
USE
•
After adding water, plug the appliance in.
•
Press the power button. The red standby light will start to blink. Wait
for about 30 seconds for the standby light to stop blinking. This
indicates the preheating is finished and the machine is ready to
use.
•
Hang the clothes that you wish to steam in an area that will not be
impacted by the heat and steam, such as on a shower rod. Try to
straighten the clothes as much as possible. Press on power button to
select desired steam flow, once for low or twice for high. Press the
steam switch to start steaming, and click down if you wish to have a
continuous steam flow.
•
Aim the head toward the clothes. Holding the steamer
approximately 1 inch from the fabric, move in a slow, continuous
www.KALORIK.com
6
GST 47574 - 200605
Publicité
