Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Contents of Carton
1 - Air Compressor
1 - Parts bag containing:
1 - Owner's Manual
4 - 5/8" Washers
1 - Conduit Connector
Tools Required for Assembly
1 - 9/16" socket or open end wrench
1 - Electric drill
Unpacking
1.
Remove all packaging.
will have a tendency to tip.
2.
Remove and discard the (4) screws and washers holding the compressor to
the pallet.
3.
With the help of another person carefully remove air compressor from pallet
and place on a level surface.
under Maintenance.
HOW TO SET UP YOUR UNIT
Location of the Air Compressor
•
Locate the air compressor in a clean, dry, and well ventilated area.
•
Located the air compressor at least 12" (30.5 cm) away from the wall or
other obstructions that will interfere with the flow of air.
•
Locate the air compressor as close to the main power supply as possible
to avoid using long lengths of electrical wiring. NOTE: Long lengths of
electrical wiring could cause power loss to the motor.
•
The air filter must be kept clear of obstructions which could reduce air flow
to the air compressor.
Anchoring of the Air Compressor
properly mounted.
The air compressor MUST be bolted to a solid, level surface.
Hardware needed:
4 - Concrete anchors (not supplied)
4 - 3/8" Lag screw to fit concrete anchors (not supplied)
4 - 5/8" Washer (supplied) shims (if needed)
1.
Place the air compressor on a solid, level surface.
2.
Mark the surface using the holes in the air compressor feet as a template.
3.
Drill holes in the surface for the concrete anchors. Install concrete anchors.
ASSEMBLY
It may be necessary to brace or support one side of the
outfit when removing the pallet because the air compressor
This compressor was shipped with oil in the pump crankcase.
Check oil before operating air compressor, see Check Oil
INSTALLATION
Risk of Bursting. Excessive Vibration can weaken the air
tank and cause an explosion. The compressor must be
9-ENG
1000003473
Publicité
Table des Matières
