Tempo OPM510 Mode D'emploi page 13

OPM510 • OPM520 • SLS520 • SLS525 • SLS530 • SLS535 • SLS536
Battery Installation or Replacement
To replace the batteries, follow these steps:
1. Turn instrument off.
2. Remove battery cover by sliding down.
3. Install new battery to the wire leads observing correct polarity.
Connector Interface
All fiberTOOLS OPM and SLS units utilize a screw on adapter for SC,
LC, FC and ST configurations. The OPM and SLS instrument bulkheads
are unique in that the adapters for the OPM are different from the SLS.
Do not attempt to use a OPM adapter on a SLS or vice versa. Please
consult the accessories section of this instruction manual for adapter
part numbers.
13