Before First Operation - Black & Decker BDT20WTB Manuel D'instructions

SET UP & USE

BEFORE FIRST OPERATION

1. Grip each side of the bucket and pull to remove the bucket from the
dehumidifier (Fig. 4).
Fig. 4
2. Check inside the bucket to make sure the float system is in the correct
position. If not, place the float in the correct position (Fig. 5).
Fig. 5
3. Re-insert the bucket once you have determined the float system is in the
correct position (Fig. 6)
Fig. 6
The float in the bucket is essential to the "bucket full" system working properly.
Do not remove the float and make sure the float can rotate freely.
Page 8