Hortus 211-318 Instructions page 5

Warranty
The product warranty is pursuant to the Danish Sale of Goods Act.The warranty period starts on the day
the product was purchased.
Warranty handling
A defective product must be returned to the place of purchase along with a valid receipt. If the product
becomes defective during the warranty period, the product must be returned to the place of purchase.
Warranty disclaimer
Damage or defects resulting from neglect or improper use of the product is not covered by the warranty.
The warranty does not cover force majeure such as lightning, flood, fire or damage occurred during
transport. Warranty cover will be void, if the product's serial number has been changed, if any modifications
have been made or if a repair has been attempted by any unauthorized service centre.
Product specifications
Model no. ZHQ2125-RMLED-B
Art. No.
Power source 220-240V AC ~ 50 Hz
Consumption
Protection class
OPERATING INSTRUCTIONS
1. Place the heater on a firm, level ceiling surface.
2. The hook on the ceiling hanging the patio heater must be able to undertake a weight 3 or 4 times that of
the patio heater itself.
3. The distance between the bottoms of the Patio heater to the Floor must be over 1.8 meter (fig. 1).
4. Plug the Patio Heater into a grounded 230V ~ 50Hz power outlet.
5. The switch on the heater head is used to control the power. (I) position for turn on. (0) position for turn
OFF (fig. 2).
6. Activating button on the heater is to operate heater by manually (fig. 3).
Press one time for 800 W,
Press again for 1800W (800W +1000W),
Press third times for turning on LED light without heat,
Press four times for turning on the LED light and heater (for 1800W)
Press five times for turn off the LED light and heater.
7. Only operate the heater when it is in hanging position.
Remote control
1. Press the On/Off switch to activate the heater
2. To operate the heater on low power (800W), press on the left side button of the remote control
3. To operate the heater on medial (1000W), press on the right side button of the remote control
4. Press on both the left and right side button of the remote control for maximum power (1800W)
5. To operate the LED light, press the top button of the remote control
The main power switch must be turned on to use the remote control
211-318
1800W
IP44
Fig. 1
A. Decoration Cover
C. Heating lamp
E.Top tube
G.Bottom tube
Ceilling
I. Power Cable
min.
min.
min.
min.
Floor
A. Decoration Cover
C. Heating lamp
B .Heater Head
E.Top tube
D. Switch Box
G.Bottom tube
F. Middle tube
I. Power Cable
H. Base
Warning!
Warning: Please tea
Please tear off all
film around the big
the hyaline protect
Warning: Please tear off all the
film around the big
film around the big Decoratio
decoration cover
first!
Wall
Fig. 2
Fig. 3
B .Hea
D. Swi
F. Midd
H. Bas