Assembling - DENQBAR DQ-0139 Mode D'emploi Et D'entretien

ASSEMBLING

Handle
1
- remove the screws (1+2) and nuts
- align the handle with the upper and lower part
- now fix the screws again at the right and left side of the handle from the outside.
Be careful not to clamp the bowden cable of the throttle lever.
Transport wheel
the compactor is equipped as standard with the mounted wheel
-
before first use please make sure that all screws and nuts are properly tightened
-
during use of the compactor the transport wheel has to be fixed in the clip
-
assure that the wheel is locked in firmly into the plastic clip
-
for using the transport wheel just fold it down under the compactor by tilting him a little bit
-
2
- 28 - © by DENQBAR GmbH
www.denqbar.com