GLÄSS MIMESI Notice D'installation & Maintenance page 14

EN
Rinse thoroughly with plenty of water to remove all traces
of detergent.
Special maintenance must be carried out by qualified
personnel.
In case of failures or malfunctioning of the product, contact
only authorised technicians to avoid losing warranty rights. The
manufacturer shall not be held responsible for any damage
caused by products that have been tampered with or repaired
wrongly.
Limescale can be removed from water jet
nozzles simply by rubbing.
TROUBLESHOOTING
In the event of abnormalities run the following checklist.
All electrical connection
performed by an electrical installation technician.
If there is no response from the wall controls, check that:
- The switch is on.
- The appliance is powered. Check that the domestic power
supply is working by testing other electrical household
appliances which you know are operating correctly.
All hydraulic connection
performed by a hydraulic installation technician.
If the water is slow to drain away, check that the drain is not
blocked.
If the product does not dispense water, check that:
- There is water in the main pipe.
- The diverter is correctly set.
- There are no impurity into the pipes that prevent normal
water flow.
If the above operations do not solve the problem, contact your
nearest service centre or the company.
THERMOSTATIC MIXER
During testing, the thermostatic mixer is set so that the
mechanical stop point (button on lower part of knob) is at 38°C.
WARNING
If hot and cold water pressure in the piping system is not uniform,
further setting may be necessary.
The appliance will not operate correctly if the system pressure
is below 120k Pa (1,2 bars). If the water mains pressure is over
250k Pa (2,5 bars), a pressure reducer must be fitted upstream
of the system.
We recommend instal-ling resin filter (30/40 litres/minute) on
the delivery line in order to prevent foreign bodies etering the
circuit and damaging the mechanical parts of the mixer.
checkup must be
checkup must be
WARNING
14
SETTING
38°
FUNCTIONING
The thermostatic mixer has a safety block at 38°. To reach a
higer temperature press the button and turn the handle (A)
anticlockwise.
• turn the cock handle ( B) and place the central ax on the desired
function, as shown on the icon.
• Turn the handle (A) to adjust the temperature.
Example of functions that can be selected with the cock handle B
Shower head
Large head
Jets
B
38°
-
38°
A
38°
+38° -38°
38°
38°
+38°
B