Oven Functions And Operation - ARO SHG5056 Notice D'utilisation

OPERATION
Selection of the appropriate flame
A correctly adjusted burner has a light blue
flame with a clearly visible internal cone.
Selection of flame size depends on the posi-
tion of the burner knob which has been set:
large flame
small flame ("economical flame")
burner switched off (gas supply is cut off)

Depending on requirements, flame size can
be set in a continuous manner.
WRONG
Caution!
Do not adjust the flame between the off posi-
tion and the large flame position

Operation of the burner protection valve
Gas cooker is equipped with an automatic
system that cuts off gas supply to a burner
when the flame has disappeared.
This system protects the cooker against gas
leakage when the flame on a burner goes out
e.g. in case of spillage.
The user's intervention is needed to re-ignite
the burner.
RIGHT
.
25

Oven functions and operation

The oven can be heated by oven gas burner.
The oven function is controlled by one knob,
which contains a digital scale corresponding
to thermoregulator settings.
Oven setting 1 2
Temperature 150-160 165
in C
O
To ignite the oven:
• strike a match,
• press down the knob to the stop and turn
left to the position corresponding to the
temperature chosen,
• put the match to the ignition opening
• (see the figure below) and keep the knob
pressed down about 3 sec. from the gas
ignition moment. If the flame has gone
out, repeat the ignition operation after
lapse of 3 sec.,
The temperature control is possible at closed
oven door only.
Turn the knob right to the stop in order to turn
the oven off.
3 4 5 6 7
180 195 210 225 240
8
255