ARO SHG5056 Notice D'utilisation page 20

INSTALLATION
Caution!
The cooker may only be connected to a liquid
gas cylinder or the existing gas supply by an
authorised fitter, observing all safety rules.
The cooker has threaded ½" pipe connector.
The connector must be screwed in with a dy-
namometric spanner with a maximum torque
of 20 Nm. It is recommended to seal connec-
tions with a teflon sealing tape. If the torque
is too high or tow is used, the connection be
damaged and become leaky.
When connecting the cooker to the gas sup-
ply, a metal tip of at least 0.5 m length with
an end for a 8x1 mm hose should be screwed
onto the R1/2" terminal. In order to screw the
tip in, you should unscrew the spring of the
cover hinge. The gas hose should not touch
metal elements of the cooker back shield.
Important!
Each time you replace a reducer carry out
technical inspection of the cooker that covers
gas valves and proper operation of the flame
failure cut-off device.
Caution!
On completion of the cooker installation,
the tightness of all connections should be
checked, e.g. applying water with soap.
Do not use fire to check tightness.
20