NAUTIKA THEIA 90 CFM Manuel D'installation page 14

3. CAUTION: Dimension "B" should allow for thickness of ceiling board
used in your application. Do not flush mount to joist. Flange should be
flush with ceiling board.
4. Refer to wiring diagram on page 4. Remove the junction box cover.
Using quick connectors, connect house wires to ventilating fan wires:
black to black; white to white; green to green. Replace the junction
box cover.
CAUTION: If your house wires do not match these colors, you
must determine what each house wire represents before connecting
and you may need to con suit an electrical contractor to determine
this safely. Mount junction box cover carefully so lead wires are
not pinched.
5. Install a circular duct (not included) and secure it with duct tape or
clamps (neither included).
Finish ceiling work. Ceiling hole should be flush with the edge of the
flange. (DO NOT FLUSH MOUNT TO JOIST. Flange should be flush with
ceiling board.) See dimensions for ceiling hole on page 3. If joist is
present, insert long wood screws through flange and through ceiling
to secure fan to joist.
6. Attach plug connector to receptacle.
7. Install two (2) GU24, 13 watt bulbs (not included).
8. Pinch mounting springs on grille and insert into narrow rectangular
slots inside the fan housing next to the fan motor.
Turn on electricity at breaker box after finishing installation.
BATHROOM FAN – THEIA 90 CFM WITH 2 LIGHTS
3
4
House
wires
5
6
7
8
Wiring
box
Quick
connector
Product
wires
5