www.digisportinstruments.com
INSTRUCTION MANUAL
SCOREBOARD DT701
FEATURES:
-
24-hour clock display
-
Count up timer with range to 9 hr.
59min. 59sec.
-
Countdown timer with loud beep
RF remote control – no cords
-
required
-
Large 4 inches LCD digits for
viewing
from
as
far
away
50M(150feet)
-
Display scores of two teams up to
maximum score of 199
-
Display period number together
with possession arrow
-
Powered by AC adapter (included)
or batteries (four D size – not included)
-
Wall mounted or free standing
Figure 1
-
16 different RF channels, user-
adjustable to another channel to avoid
interference with nearby units
LIST OF ACCESSORIES
-
Wall Timer
-
Remote control with four AAA
batteries
-
Stands
-
AC adapter (For indoor use only)
-
Instruction manual
HOW TO OPEN NAME PLATE DOORS
Use a suitable screwdriver to open
the side doors as shown in Figure
2. Do this carefully to not damage the
plastic side doors. This allows the
removal or insertion of the
nameplates and ads.
FIXING THE WALL TIMER
The Wall Timer can be fixed on the wall
with two screws hooked into the eyelets
on the back top housing. Make sure the
screws are securely fixed into the wall.
The Wall Timer can also stand-alone on
the floor or on a table using the stands
of the Wall Timer as shown in Figure 3.
POWER UP:
For AC connection, use only the AC
adapter (9V) supplied with the unit.
Check the power rating indicated on the
adapters is the same as the AC power
supplied in your location. Plug the
adapter into the socket on the right side
of the Wall Timer as shown in Figure 3.
The digits will light up automatically and
be ready for setting.
as
When AC power is not available, insert
four D size batteries into the battery
compartment on the back of the Wall
Timer as shown in Figure 4. When using
batteries, the ON/OFF SWITCH can be
used to turn the Wall Timer on and off. If
the batteries are left in the Wall Timer
during AC operation, they serve as a
back up in the event of AC power
interruption. The volume switch is used
to turn the volume to HIGH, LOW or
OFF. The scoreboard remote control
needs four 1.5V AAA size batteries to
operate as shown in Figure 5.
TIME SETTING:
1) In the TIME DISPLAY MODE shown
in Figure 6, press and hold <MODE> for
3 seconds to enter in the TIME
SETTING MODE. "Hour" will be shown
as in Figure 7.
2) Press <SET/POSSESSION> to enter
in the setting mode and the time digits
will blink.
3) Adjust hour by pressing <+/-TEAM1>
and adjust minute by pressing <+/-
TEAM2>.
4) Press <SET/POSSESSION> to end
the setting.