eTIGER ES-DL02 Installation page 10

Add Users PIN(s)
User ID: 0~99
PIN length: 6 digits
Programming Step
1. Enter Program Mode:
2. Add PIN:
3. Exit:
Add Users Card(s)
User ID: 100~399
Card type: 13.56MHz M1 Card
Programming Step
1. Enter Program Mode:
2. Add Card:
Using Auto ID (Allows to assign Card
tonext available User ID number)
OR
Add Card:
Select Specific ID (Allows Master to
define a Specific User ID to associate
the card)
3. Exit:
Add finger print (s)
User ID: 400~499
Programming Step
1. Enter Program Mode:
2. Add fingerprint: Using Auto ID (Allows
to assign fingerprin to next available
User ID number)
Add fingerprint: Select Specific ID
(Allows Master to define a Specific User
ID to associate the fingerprint)
3. Exit:
Change PIN
Note: Below is done outside programming mode, users can undertake this themselves
Programming Step
1.Change PIN:
By Card (There will be auto allocate PIN
(8888) to cards when adding)
OR
Change PIN: By User ID
2. Exit:
Keystroke Combination
* (Master Code) #
1 (User ID) # (PIN) # (Repeat PIN) #
The users can be added continuously
*
Keystroke Combination
* (Master Code) #
1 (Read Card) #
OR
1(User ID) # (Read Card) #
*
Keystroke Combination
* (Master Code) #
1(Readfingerprint)#
1(User ID) #(Readfingerprint)#
*
Keystroke Combination
* (Read Card) (Old PIN) # (New PIN) #
(Repeat New PIN) #
* (User ID) # (Old PIN) # (New PIN) #
(Repeat New PIN) #
Exit automatically