Hirschmann Hit CKR 504 Mode D'emploi page 6

Universal Quatro
receiving system
V/H low band
V/H high band
Sat
F
18 V (H) / 22 kHz (high)
18 V (H) / 0 kHz (low)
13 V (V) / 22 kHz (high)
13 V (V) / 0 kHz (low)
EDA 3902 F
EDA 3902 F
Installation
• Install the unit on a flat surface in a place
protected from moisture using suitable
screws
• Fit crimp or screw-on plugs to the cables,
screw onto the F-sockets on the unit and
tighten
• Note:
Please see the current catalogue for
crimp or screw-on plugs matched to
the respective cable
• Ensure that remote feed voltage is not
(yet) present on the connecting cables
6
outputs
outputs
• Connect the outputs on the receiving
• Unused outputs on the multi-switch are to
• To ensure electrical safety, it is imperative
Terr. input: 5 - 862 MHz
Sat.: 950-2400 MHz
F.: Remote feed voltage
Terr. input
Multi-Switch Hit CKR...
=
~
EDA 3902 F
EDA 3902 F
system (LNB) to the inputs on the multi-
switch with the same markings
be terminated with termination resistors
(e.g. RFC 75)
that the VDE directives 0860 (corresponds
to EN 60065) and VDE 0855 (corresponds
to EN 50083) are observed!
Multi-Switch Hit CKR...