Publicité
Les langues disponibles
Les langues disponibles
6. Activation of
button
Gate open:
Connect the automatic gate opener directly to the terminals at the back of the
roadside panel which supplies a current-free "dry" contact to connect to the "push
button" control of your automatic gate opener.
This function can only be used when the screen is switched on. It is normal that
the image switches off one moment following the control of the gate opener.
If you want to open the gate to let the caller in,just touch the
indoor monitor.
7. Change the melody
At standby mode, touch the
choose target melody. There are 4 melodies available. To confirm melody you have
chosen, touch
button.
Care and Maintenance
Do not store in hot or cold areas. Extreme hot or cold temperatures can shorten
the life of electronic devices and can distort/melt certain plastics or may cause
malfunction.
Dropping can result in failure to operate. Circuit boards can crack and may not
survive the impact.
Do not use or store in areas of high levels of dirt or dust. The electronics may be
contaminated. Any moving parts will wear prematurely.
Do not use harsh chemicals, cleaning solvents or strong detergents. To clean,
wipe with a damp cloth from time to time.
Troubleshooting
No Problem
1
No power
(no picture on monitor)
2
Power is on, but no picture on
the monitor
3
The picture is too dark or white
4
Chime sound is too low
Environmental Protection
• Waste electrical products should not be disposed of with household
waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice.
Version 8.1
All manuals and user guides at all-guides.com
button, you can hear the melody. Then touch
Check point
button on the
Is the AC plug firmly inserted into
the AC outlet?
Is the cable firmly connected
between the monitor and the
camera?
Is the polarity of wires correct
between the outdoor camera unit
and indoor monitor unit?
Adjust brightness control
Adjust the volume control
to
Page
23
Publicité
