Getting Started; Operation; Care Of Your Bottle Warmer - weewell WEM500 Mode D'emploi

20
20
20
20
28
28
28
28
28
*All measures are given approximately
Remember the ideal feeding temperature is just 37˚C (same as breast milk)
ALWAYS check the temperature of the baby milk and food before feeding
your baby.

Getting started

1. Before use, ensure that the warmer and accessories (including mains cable) do not have
any visible damage.
2. Place the holder into the device.

Operation

1. Add required amount of water according to table above into the bottle warmer.
2. Place the baby bottle or jar into bottle rack.
3. Plug the power cord into your socket at home and make sure the wall switch is turned on,
press and button, it may be set from 1 to 12 minutes.
4. The heating cycle is complete when the heating stops and warmer bleeps.
5. Remove the bottle or jar from the bottle warmer, always check the temperature of the
food yourself before feeding to your baby.
6. Unplug the bottle warmer from the mains supply and leave to cool down before cleaning.

Care of your bottle warmer

• The bottle warmer must never be immersed in water, after unplugging form the electricity
supply and allowing to cool down the bottle warmer can be wiped clean and dried with a
clean non abrasive cloth.
• Lime residues found on the heater plate are quite normal and the severity will depend on
where you live and the hardness of your local tap water, these residues may be periodi-
cally removed by using a dilute solution of 1 part vinegar to 2 parts water, pour into the
heater tray and leave for an hour, rinse off and clean before reusing to heat bottles.
4 I WEM500 USER MANUAL
All manuals and user guides at all-guides.com
100 25
150 65
200 45
250 85
50 100
100 60
150 110
200 100
250 105
2 39
3 39
3 39
4 39
2 39
2 39
3 39
3 39
3 39